bushings
英[]
美[ˈbʊʃɪŋz]
- n. [电]套管;轴衬;支架避震组(bushing 的复数形式)
双语例句
- 1. Level3: Tolerance matching of freewheel bushings. Factory only.
- 级别3:飞轮轴套的公差矫正。只有工厂可以操作。
youdao
- 2. Upper and lower bushings are standard for smooth valve operation.
- 上部和下部衬套符合流畅平稳轻松操作阀门的标准要求。
youdao
- 3. Bronze Bushings: High side load capabilities, self lubricating, long life.
- 青铜衬套:高侧的负载能力,自润滑,寿命长。
youdao
- 4. Exposed to elevated temperatures with some finishes intact or bushings installed.
- 暴露到恶劣的温度条件下,接触到涂层或装有衬套。
youdao
- 5. Note that on Fire Protection models adaptor bushings may differ from illustration.
- 注意:消防防火型号阀门的适配器衬 套可能与图示不同。
youdao
- 6. The bushings included with many starter cars eventually become sloppy and wear out.
- 该衬套包括许多起动汽车最终成为马虎和磨损。
youdao
- 7. Many RC cars include bronze bushings on their moving parts rather than ball bearings.
- 许多遥控汽车包括他们的移动部件,而不是球轴承青铜衬套。
youdao
- 8. Step bushings are placed in all key pivot areas to increase strength and reduce stress.
- 重要枢 轴均采用阶梯衬套,以便增加强度和减小应力。
youdao
- 9. Un-housed VCA shipped as Coil Assembly and Field Assembly, without shaft and alignment bushings.
- 非封装音圈调节器线圈,现场组装,船运不配自调整轴承和绝缘套管。
youdao
- 10. This should last at least until I locate or learn to machine bronze bushings or maybe I'll leave it.
- 这应该至少持续,直到我找到或学习机青铜衬套或也许我会离开。
youdao
- 11. Bushings: Furnishes shaft support at three locations for positive shaft alignment and actuator support.
- 衬套:在三个位置上配置轴支撑,有利于轴校直和执行机构的支撑。
youdao
- 12. The molten glass flows through orifices and temperature resistant bushings at the base of each furnace.
- 熔融的玻璃液流过喷丝头以及熔炉底部的耐高温衬套。
youdao
- 13. The linear bushings and linear sets of the eLINE series are supplied in a clearance-free configuration.
- 线性衬套和埃利纳系列线性集提供了无间隙的配置。
youdao
- 14. It is a specialized manufacturer that produces wearing parts like fixed bushings and removable bushings.
- 系生产轴承附件——紧定衬套、退卸衬套系列产品的专业厂家。
youdao
- 15. Guide rods are supported by specially designed guide bushings providing optimum support of dynamic loads.
- 导杆的支持,特别设计的指导,提供最佳的动态负载支持轴套。
youdao
- 16. Recommended for use on aluminum conduit, bolts, bushings, fittings, flanges, nuts, pipes, plugs and screws.
- 推荐使用在铝管、螺栓、套管、配件、法兰盘、螺母、管线、塞子和螺丝。
youdao
- 17. Other applications where high carbon steels are well suited include drill bushings, locators, and wear pads.
- 高碳钢也很适用的其它地方包括钻头夹头、定位仪和耐磨垫。
youdao
- 18. Bushings (4) : Furnishes shaft support at three locations for positive shaft alignment and actuator support.
- 衬套(4):在三个位置上配置轴支撑,有利于轴校直和执行机构的支撑。
youdao
- 19. Do not drop or kick the master rotary bushings into position. Always use insert tools and hoist them into place.
- 不要投放或踢放大方瓦,应当用专用工具提着放入。
youdao
- 20. A special fixture-cylindrical sleeve is presented for mechanical processing of bushings with small inner diameter.
- 针对小孔径瓷套机械加工难度大的问题,介绍了一种特殊的工艺装备套筒。
youdao
- 21. This instrument is appropriate for testing cables, capacitors, transformers, bushings, coils of high voltage machines, etc.
- 仪器适用于测试电缆、电容器、互感器、套管和高压电机的线圈等。
youdao
- 22. A higher gear after heat treatment the hardness and strength, and the shaft can be replaced with bushings installed in the operation.
- 齿轮经热处理有较高的硬度和强度,与轴一同安装在可更换的轴套内运转。
youdao
- 23. By turning a pair of composite eccentric bushings in the chassis and top deck, you can move the complete assembly forward or backward.
- 把一对复合偏心轴套在底盘和顶部甲板上,您可以提出完整的大会,向前或向后。
youdao
- 24. The solution was a plastic, external cover (including the switch handle) isolated from the mechanism housings by large rubber bushings.
- 解答是塑料,外在盖子(包括开关把柄)与机制住房被隔绝由大橡胶轴衬。
youdao
- 25. Our company's main automotive water, air tube, dust cover, silicone tube seal, pull, engine brackets, bushings and other rubber products.
- 本公司主营汽车水管、空气管、防尘套、硅胶管、密封条、拉线、发动机支架、衬套等橡胶制品。
youdao
- 26. SIBA Capacitor protection fuses can easily be fitted direct onto capacitor bushings, because they are fitted with threaded holes at both ends.
- 待职电容器保护保险丝可以轻松地装上直接上电容器衬套,因为他们是装有螺纹孔两边。
youdao
- 27. While pulling the BHA through the rotary table, the Driller must stop when stabilisers reach the table and have the Floormen remove the bushings.
- 当起钻到BHA,扶正器到达钻盘面时,司钻必须刹住刹把,让钻工移开方补心。
youdao
- 28. They include a wider track front and rear, suspension knuckles that lower the roll center, larger anti-roll bars, and revised bushings and shocks.
- 这些措施包括更广泛的轨道前方和后方,暂停关节,降低轧辊中心,大型防倾杆,并修订衬套和冲击。
youdao
- 29. According to the usage, the insulators can generally be divided into three broad categories: line insulator, substation post insulator and bushings.
- 按用途一般可分为线路绝缘子、变电站支持绝缘子子和套管三大类。
youdao
- 30. The die forging process for the small type bearing bushings has been described in this article, as well as the design outline of the assembled sleeve die.
- 介绍了小型轴承套的胎模锻造工艺,并详述了组合套模的设计要点。
youdao
百度翻译
有道翻译