head-plate
英[]
美[hed pleɪt]
双语例句
- 1. The metal plate behind my head radiated heat.
- 我脑后的金属盘散发出热量。
《柯林斯英汉双解大词典》
- 2. He takes the plate that holds the pig's head and puts it on the floor under the table.
- 他端起盛猪头的盘子,放到桌下的地板上。
youdao
- 3. That was when a huge plate crashed on his head and knocked him out.
- 就在这时,一个大盘子击中了他的脑袋,把他给砸昏了。
youdao
- 4. At this moment the door of the house opened, and a large plate came skimming out, straight at the Footman's head: it just grazed his nose, and broke to pieces against one of the trees behind him.
- 就在这时,这个房子的门开了,一只大盘子朝仆人的头飞来,掠过他的鼻子,在他身后的一棵树上撞碎了。
youdao
- 5. Yes, soldiers took her out and came back with her head on a big plate, her eyes were wide open.
- 对,禁军将她带出,回来时端着一个大盘子,人头摆在上面,双眼圆睁。
youdao
- 6. 'I was upset by what was happening, and I thought as I went out the door: "I'd smash a plate over your head if you were my husband!"
- 我为所发生的事情感到难过,当我出门的时候听见:‘如果你是我丈夫我就用盘子砸你的脑袋!’
youdao
- 7. He was unconscious for several weeks and woke up with a metal plate in his head.
- 有好几个星期他都神志不清,等他醒来的时候,脑袋里已经被装了块金属板。
youdao
- 8. Even after the plate that her husband then threw grazed her on her head.
- 即使在她丈夫扔出去的盘子擦伤了她的头部之后。
youdao
- 9. With several strokes of black lines at the head, face and hands, the character in this plate is vividly portrayed.
- 这个漆盘上的人物只是在头部、脸部和手等部分用黑线勾画,鐀寥寥数笔,表情很生动。
youdao
- 10. Based on the cause of gauge oversizing of plate head, the traditional head gauge compensation methods were analyzed.
- 基于中厚板轧制过程中头部厚度超差原因,分析了传统的头部补偿方法的不足之处。
youdao
- 11. Malala's head and the fragment changed, so this weekend, the surgeons attached a titanium plate to her skull.
- 马莱拉的头部和这部分发生了改变,所以这个周末,外科医生们附加了一块钛板到她的头骨内。
youdao
- 12. A formed head shall generally be made of single plate.
- 成型的封头通常应用单板制作。
youdao
- 13. Locking head screws will not have optimal fixation if the plate is not sitting over the middle of the bone surface.
- 如果钢板没有放在骨界面的中央,锁定头螺钉将不能达到最佳的固定。
youdao
- 14. It is ideal for sealing all the random gaps between dummy bar head and mould copper plate, to prevent the hot metal infiltration and break out while casting.
- 非常适合于引锭头与结晶器铜板之间无规则缝隙的密封,防止开浇时渗、漏钢的现象的出现。
youdao
- 15. NOTE: the disc holder should not be removed when servicing only the disc, remove Allen head screws holding the disc retaining plate and replace disc.
- 注意:如果只是维修阀瓣,就不要拆卸阀瓣固定器,只需拆卸支撑阀瓣固定器板的六角头螺丝和拆卸阀瓣即可。
youdao
- 16. Head cover is of a welded structure of the Q235 steel plate with sufficient strength.
- 顶盖为Q 235钢板焊接结构,具有足够的刚强度。
youdao
- 17. A balance plate is put into the pump head to balance the axial force without lowering efficiency and a good effect got.
- 在不降低效率的情况下,在屏蔽电泵的泵头加入平衡盘使轴向力得到平衡,并取得了满意的效果。
youdao
- 18. Conventional wisdom tells us that you can truly feed your head. But can what's on your plate really affect how you feel or think?
- 普遍认为我们可以通过食物来补充大脑所需要的营养。但是盘中食物能否影响你的感觉和想法呢?
youdao
- 19. The factors of influence on head end curl of plate and sheet in rolling were researched by the cross experiment.
- 用正交实验方法,对影响板带材轧制头部翘曲的因素进行了研究。
youdao
- 20. If the meal to be put down knife and fork, it should be placed on both sides of the plate, knife and fork, head inward.
- 如在用餐时要放下刀叉,应将其放在盘子两边,刀与叉子头向内。
youdao
- 21. Medieval plate armor to protect a horse's head .
- 中世纪一种保护马头部的盔甲。
youdao
- 22. Align the hex plate with the receiver on the head and gently press down until the lock clicks into place (figure 13).
- 然后将六角形快装板与云台上的对应处对齐,接着轻轻按下直到锁紧(图13)。
youdao
- 23. The key points to remember when selecting a head are how smoothly it moves, how much weight it can safely support and whether it has a quick release plate.
- 选择云台的几个要点,云台的运动是否平滑,云台的安全承重量,是否配置快装板。
youdao
- 24. It can increase the hole inclination Angle range and drill elevation Angle holes, while setting the top drive power head and hole top plate toward the opposite direction.
- 动力头及孔口板调转方向,可直接钻凿仰孔,大大增加钻孔倾角范围。
youdao
- 25. A large plate came skimming out, straight at the footman 's head.
- 一只大盘子直向听差的脑袋飞来。
youdao
- 26. Upper device — includes parts of upper casing, top cover, discharge outlet (with anti back feed plate), head shaft and backstop.
- 上部装置——有上部机壳、上罩、卸料口(装有防回料板)、头轴装配、逆止器等部件。
youdao
- 27. The main wearing parts for mill include liner plate for mill body, liner plate for mill head, partition screen plates, blind plate and outlet screen plate etc.
- 磨机易磨部件包括筒体衬板、磨头衬板、各仓隔仓筛板、盲板、出口筛板等。
youdao
- 28. The main wearing parts for mill include liner plate for mill body, liner plate for mill head, partition screen plates, blind plate and outlet screen plate etc.
- 磨机易磨部件包括筒体衬板、磨头衬板、各仓隔仓筛板、盲板、出口筛板等。
youdao
百度翻译
有道翻译