microhardness
英[ˌmaɪkrəʊˈhɑːdnɪs]
美[,maikrəu'hɑ:dnis]
双语例句
- 1. The microhardness of the coating was measured.
- 测试了涂层的显微硬度。
youdao
- 2. The hardness was measured by the microhardness tester.
- 用显微硬度仪测试了试样的显微硬度。
youdao
- 3. The microhardness increases remarkably near the interface.
- 界面区显微硬度显著提高。
youdao
- 4. The roots were sliced and root-dentin microhardness was measured.
- 用微硬度测定仪检测根管牙本质的微硬度。
youdao
- 5. Methods: Tension test machine and microhardness tester were used.
- 方法:用拉力机、显微硬度机测试。
youdao
- 6. The microstructure, microhardness and depth of the nitrided layers were studied.
- 对渗氮层的硬度、深度和组织结构等进行了分析研究。
youdao
- 7. Microhardness on the surface layer were measured by microhardness testing machine.
- 利用显微硬度试验机来测量表面显微硬度。
youdao
- 8. The surface microhardness was substantially increased compared with the untreated.
- 表面显微硬度较未处理的样品明显提高。
youdao
- 9. The feasibility of this method is confirmed by comparison with microhardness method.
- 在与硬度法的对比试验中,进一步验证了电阻法的可行性。
youdao
- 10. Moreover, when CO2>30%, the process stability and microhardness of weld dramatically decrease.
- 当CO2含量>30%后,复合焊接工艺稳定性变差,焊缝硬度急剧降低。
youdao
- 11. The microstructure, microhardness and dry-sliding wear resistance of the coating were evaluated.
- 并对涂层的显微组织、显微硬度和室温干滑动实验进行了具体分析。
youdao
- 12. Microhardness testing during aging treatment in high purity steel bearing copper was carried out.
- 对经时效处理后的含铜高纯钢进行了显微硬度测试。
youdao
- 13. In addition, the trend of microhardness variety could not accord with the ultra-plastic wave formula.
- 合金的显微硬度变化趋势不符合超塑性波动公式。
youdao
- 14. The effect of heat treatment temperature on the microhardness and magnetic properties were investigated.
- 研究了热处理对镀层显微硬度和磁性能的影响。
youdao
- 15. The layer is smooth with higher microhardness, corrosion and bonding strength by using the proper process.
- 在合适的电刷镀工艺下,镀层表面平整、光滑,具有较高的显微硬度、耐蚀性和结合强度。
youdao
- 16. The results show that the parameters have great effect on microstructure and microhardness of the coatings.
- 结果表明,工艺参数对冶金层显微组织及显微硬度有很大的影响。
youdao
- 17. The microhardness and surface roughness of specimens before and after shot peening was studied and analysed.
- 分析研究了喷丸强化处理前后的显微硬度和表面粗糙度。
youdao
- 18. The microhardness test was used to determine the behaviour and the extent of the interfacial transition ring.
- 本文还通过显微硬度试验测得界面过渡环的性状及范围。
youdao
- 19. The microhardness value of the amorphous alloy is lower than that of the crystalline alloy with the same composition.
- 显微硬度测试表明,对相同成分合金,非晶态的显微硬度值比晶态的低。
youdao
- 20. The high frequency induction hardening can't raise the surface microhardness of the cold precision forging spur gear.
- 高频感应淬火不能达到硬化冷精锻直齿圆柱齿轮齿面的目的。
youdao
- 21. The depth and microhardness distribution of alumetizing layer obtained on different technical conditions were measured.
- 测定了不同工艺条件下获得的浸渗层深度和浸渗层显微硬度的分布。
youdao
- 22. The flexural strength and hardness of the specimens were tested with an instron testing machine and a microhardness tester.
- 分别以应力分析仪和显微硬度仪测试两组试件的挠曲强度和硬度值。
youdao
- 23. Objective To investigate the influence of fluoride foam of different concentration on microhardness of demineralized enamel surface.
- 目的观察不同浓度氟泡沫对脱矿牙釉质表面显微硬度值的影响。
youdao
- 24. The microhardness of nitriding layers obtained in a wide range of treatment temperature is 5 ~ 6 times higher than that of the substrate.
- 可在较宽的温度范围内对该钢进行脉冲直流等离子渗氮,获得表面硬度高于基底5 ~6倍的渗氮层。
youdao
- 25. These results indicate that the microhardness of crystals depends not only on the crystal structure and lattice energy but also on temperature.
- 最后指出晶体硬度不仅与晶体的结构、晶格能有关,而且也与温度的影响有关。
youdao
- 26. The depths and its uniformity of the surface hardened layer, its microhardness and wear resistance are further improved under two-passes grinding.
- 双程磨削淬硬可使表面硬化层深度及其均匀性、显微硬度及耐磨性得到进一步提高;
youdao
- 27. The depths and its uniformity of the surface hardened layer, its microhardness and wear resistance are further improved under two-passes grinding.
- 双程磨削淬硬可使表面硬化层深度及其均匀性、显微硬度及耐磨性得到进一步提高;
youdao
百度翻译
有道翻译