welds
英[weldz]
美[weldz]
- 焊接点(weld 的名词复数),熔接点
- [植]淡黄木樨草
- [机]熔接(weld 的第三人称单数),[机]焊接
双语例句
- 1. Minimum of three tack welds.
- 最少有三个点焊。
youdao
- 2. Factory and site welds.
- 工厂及现场焊接。
youdao
- 3. Iron welds easily.
- 铁易焊接。
youdao
- 4. Then before I primer it I will do the welds.
- 然后之前,我引它,我会做的焊缝。
youdao
- 5. All welds shall be undetectable in finished work.
- 完成设备的所有焊接应无法探察。
youdao
- 6. Welds are marked in accordance with the procedure.
- 焊缝应按照程序进行标记。
youdao
- 7. The welds on the board are scanned with lasers for defects.
- 电子版上的焊缝会用雷射光来检查有没有瑕疵。
youdao
- 8. The body - bonnet welds are made on fully automatic MIG Welders.
- 阀体-阀帽的焊接工艺是采用完全自动化的mig焊接设备进行的。
youdao
- 9. A steady exchange of information welds them into a single system.
- 稳步的信息交流将它们焊接成一个单一的系统。
youdao
- 10. Round off al rough welds and sharp edges, remove al weld patterns.
- 对所有锐边和焊缝进行倒圆,打磨除去焊接飞溅物。
youdao
- 11. These values mentioned above are also to be used for butt-joint welds.
- 这些价值以上提到并且将被使用为接界联接焊接。
youdao
- 12. The strength and plasticity of welds were equivalent to the base metal.
- 焊接接头强度、塑性均可达到与母材相当的水平。
youdao
- 13. It can satisfy the requirement of automatic testing to tubular joint welds.
- 可满足对管节点焊缝质量进行自动检测的要求。
youdao
- 14. Seal welds shall be welded with half the thickness of the carrying fillet weld.
- 密封焊道应焊成现填角焊缝厚度的一半。
youdao
- 15. Steel welds are classified into three grades in order to evaluate their quality.
- 按照焊缝质量级别确定的原则,将焊缝级别分为三个等级;
youdao
- 16. Welds should be grinded after reworking to keep the shape similar to the old welds.
- 返修后的补焊焊缝必须修磨表面,使其外形与原焊缝大体一致,不得过宽过高。
youdao
- 17. Indicates concave, convex or flush welds. Increase height to fit above other weld symbol.
- 指示凹焊缝、凸焊缝或平焊。增加高度以配合其他焊接符号。
youdao
- 18. If tack welds are to be fused into the final joint they shall be included in the test piece.
- 如果临时点焊熔入最终的焊缝,它们应包括在试件内。
youdao
- 19. Cracks have been found in the flange and web splices at groove welds in at least four Bridges.
- 至少在四座桥梁的翼缘板和腹板拼接坡口焊缝中发现了裂纹。
youdao
- 20. No spalled paint exists at the plug weld and for a short distance each side of the plug welds.
- 在塞焊焊缝处及塞焊周围距离内无细漆碎屑存在。
youdao
- 21. When welding is required, all welds are subject to leak test to ensure the washer is water tight.
- 当需要焊接时,所有的焊接需进行泄漏测试,以确保清洗机没有任何漏水处。
youdao
- 22. But the wild child boldly gets rid of him with a fluid shield and has yielded a building without welds.
- 但这狂野的小孩勇敢地以一种流体质除去了他,成功地生产了一座无焊点的建筑。
youdao
- 23. The microstructure evolution in HAZ of Welds is a complex procedure, which associates with many factors.
- 焊接热影响区微观结构演化与诸多因素密切相关,是一个复杂的过程。
youdao
- 24. Hydroformed parts are stronger and weigh less due to structural integrity and fewer welds or add-on pieces.
- 内高压成形零件的强化,以及重量更轻,由于结构的完整性和减少焊接或添加件。
youdao
- 25. The paper points out, that both joint strength and weldability should be considered, while selecting welds.
- 并指出对焊缝的选择,既要考虑连接强度,又要考虑加工的可能性。
youdao
- 26. An "interbody fusion" is a bony bridge that "welds" the two vertebral bodies together to stop unstable motion.
- “椎体融合术”就是将两个脊椎连接起来防止脊椎不稳定的手术。
youdao
- 27. You can either use it as welds and leave it on or remove it and get good scribes just like Kevin is on the Oscar.
- 您可以使用它作为焊缝和离开它或将它移除,并得到良好的文士,就像凯文是关于奥斯卡奖。
youdao
- 28. These jigs are essential to ensure the best quality welds and the minimum of distortion during the welding process.
- 这些夹具是必不可少的,以确保最优质的焊接变形和焊接过程中最低。
youdao
- 29. These jigs are essential to ensure the best quality welds and the minimum of distortion during the welding process.
- 这些夹具是必不可少的,以确保最优质的焊接变形和焊接过程中最低。
youdao
百度翻译
有道翻译